Agriculture Apps

Vineyard Drip Irrigation System Startup

Follow these vineyard drip irrigation system startup recommended procedures with this checklist app. Using these guidelines, you can help prevent negative impacts and ensure the system is performing as expected - to help your wine growing efforts. These checklist items cover the various possible issues that can impact the drip system, with suggestions to prevent potential damage.

Based on material from Vineyard Team.

Vineyard Drip Irrigation System Startup iPhone, iPad Vineyard Drip Irrigation System Startup Android Vineyard Drip Irrigation System Startup Web, Desktop
Vineyard Drip Irrigation System Startup

Irrigation System Name

Run the well pump for a few minutes discharging the water somewhere other than the irrigation system before sending water to the filter. Over the winter, sand or other particulates may have collected in the water around the pump. Discharge of this material as a “plug” will cause problems for the filter.

Inspect the filter(s) for sand media filters, consider whether it is time to replace the media. For screen filters, check for holes in the screen and general wear and tear on and around the screens. Damage may be due to sand from the well and should be addressed.

Close all submain valves. Open mainline flush valves and run the system until discharge water runs clear for 5 minutes.

Close the mainline flush valves and open submain valves with flush manifolds open to clear the submains of debris.

Flush the submains until the water at the end of the laterals runs clear. If there is not enough pressure and velocity to maintain a strong flow, consider flushing a few lines at a time. Close the submains.

Close the flush manifolds on lateral ends.

Operate the system until it is fully pressurized and all air is discharged block by block as it was designed.

Starting from the well, check the system for leaks and necessary repairs.

Check each individual row for missing emitters or other damage.

Make sure to check drip risers and any other parts of the system which are above ground for damage.

If you make repairs, be sure to re-flush the lines after leaks are repaired.

Check pressures at key points in the system with gauges and adjust all pressure regulators and pressure-regulating valves as necessary.

Other System Components

Pumps run when they should

Controllers work

Air vents actually let air out and keep water in

Try out the fertilizer injector without fertilizer

Check that pressure gauges on the filters are accurate